Description
VOOPOO Argus Pod 20W Pod System
The Argus Pod sits at the small end of VOOPOO’s Argus line: an 800mAh internal battery, 5-20W adjustable output, and a 2ml side-fill cartridge with the coil built in. Zinc alloy construction with a leather panel, a 0.69-inch OLED that reads out resistance and remaining power, and an airflow switch on the side. It is a mouth-to-lung device by design, not a cloud machine, and it runs on the same cartridge platform as the rest of the Argus pod family.
Highlights
5-20W adjustable, resistance range 0.5ohm to 3.0ohm
800mAh internal battery, Type-C charging
2ml cartridge, side fill behind a silicone stopper, integrated mesh coil
0.69-inch OLED with adjustment buttons, plus draw activation
Four-hole adjustable air inlet
GENE.AI 1.2 chip, magnetic cartridge connection
Ships with a 0.7ohm and a 1.2ohm cartridge
Argus Pod 20W Specs
SpecDetail
Wattage
5-20W, adjustable
Battery
800mAh internal, non-removable
Charging
USB Type-C
Voltage
3.2-4.2V
Resistance range
0.5ohm to 3.0ohm
Cartridge capacity
2ml, side fill, silicone stopper
Coil
Integrated mesh, replaced with the whole cartridge
Display
0.69-inch OLED
Airflow
Four-hole adjustable air inlet
Operation
Draw activated, with adjustment buttons
Body
Zinc alloy with leather panel, magnetic cartridge connection
Chipset
GENE.AI 1.2
Protection
8s overtime, short circuit, overcharge, low battery, over-current
Pods That Fit
PodResistancesFillNotes
Argus POD Cartridge
0.7ohm, 1.2ohm
Side fill, 2ml
The cartridge the kit ships with
Argus Top Fill V2 Pods
0.4ohm, 0.7ohm, 1.0ohm
Top fill, 3ml
The newer Argus family pod, sold as a 3-pack. See the note below on the 0.4ohm
VOOPOO rates the 0.4ohm Top Fill pod for 18-30W. This device tops out at 20W, so that pod will fire but only at the very bottom of its band. For the Argus Pod, stick with a 0.7ohm or 1.0ohm. The same cartridge platform carries across the family, including the Argus G 25W and the Argus G2.
Which Resistance to Start With
ResistanceDrawBest For
0.7ohm
Looser mouth-to-lung
Freebase e-liquid, or lower-strength salt
1.0ohm
Tight mouth-to-lung
Nic salt, on the Top Fill pod
1.2ohm
Tightest draw in the range
Nic salt at 25-50mg, on the Argus POD cartridge
In the Box
Argus Pod device
1x 0.7ohm Argus POD cartridge
1x 1.2ohm Argus POD cartridge
Type-C cable
User manual
Why Shop VOOPOO at Central Vapors
The Argus cartridge platform is the reason this device ages well: we stock all three Argus Top Fill V2 resistances, and they carry across the Argus pod family, so moving up the line later does not strand your spares. Central Vapors has been filling vape orders since 2013, and every order is backed by our satisfaction guarantee.
Common Questions
Q
Which pods fit the Argus Pod 20W?
Two cartridges from the Argus family. The 2ml side-fill Argus POD cartridge in 0.7ohm or 1.2ohm, which is what the kit ships with, and the 3ml Argus Top Fill V2 pod in 0.7ohm or 1.0ohm. Skip the 0.4ohm Top Fill here, since VOOPOO rates it for 18-30W and this device caps at 20W.
Q
Can I replace just the coil?
No. The mesh coil is built into the cartridge, so when the flavor drops off you swap the whole cartridge rather than a separate coil.
Q
Is 20W enough?
For this cartridge platform, yes. The 0.7ohm and 1.2ohm cartridges are built for mouth-to-lung vaping and do not need more than 20W to run properly. If you want restricted direct lung and a bigger draw, the Argus G2 at 30W is the better fit.
Q
How do I refill the cartridge?
Pull the cartridge off the magnetic connection, lift the silicone stopper on the side, and fill. The Top Fill V2 pod fills from the top instead, without coming out of the device.
Q
Do I have to press a button?
Only to change wattage. Firing is draw activated, and the 0.69-inch OLED shows the resistance it read off the cartridge along with battery level.
Q
What is the step up from this kit?
The Argus G 25W keeps the same cartridge and adds a…
